Smart Module Series
SC200E_Series_Hardware_Design 12 / 115
1 Introduction
This document, describing SC200E series and its air and hardware interfaces connected to your
applications, informs you of the interface specifications, electrical and mechanical details, as well as
other related information of the module.
With the application notes and user guides provided separately, you can easily use the module to design
and set up mobile applications.
FCC Certification Requirements.
According to the definition of mobile and fixed device is described in Part 2.1091(b), this device is a
mobile device.
And the following conditions must be met:
1. This Modular Approval is limited to OEM installation for mobile and fixed applications only. The
antenna installation and operating configurations of this transmitter, including any applicable source-
based timeaveraging duty factor, antenna gain and cable loss must satisfy MPE categorical Exclusion
Requirements of 2.1091.
2. The EUT is a mobile device; maintain at least a 20 cm separation between the EUT and the user’s
body and must not transmit simultaneously with any other antenna or transmitter.
3. A label with the following statements must be attached to the host end product: This device contains
FCC ID: XMR2022SC200ENA
4. To comply with FCC regulations limiting both maximum RF output power and human exposure to RF
radiation, maximum antenna gain (including cable loss) must not exceed:
radiation, maximum antenna
gain (including cable loss)
must not exceed: Operating
Band
To Next Page
Loading...
Need help?
General
