Highest Ambient Temperature 40℃
Temperature Stability ±2℃/Without air flow and no load
Tip to Ground Resistance
<2Ω
Tip to Ground Potential <2mV
Heating Element Electromagnetic heater
Dimension 96(W)×160(L)×135(H) mm
Weight (not including handle length) 1.38Kg
Iron hand
Can select 901A or 901C iron hand; 901A
match 200 tips,901C match 200G tips
* The tip’s temperature is measured by 191/192 thermometer.
* Specifications and design subject above may be changed without notice.
(2) Choose a low and suitable temperature, this will protect the tip from
being oxidized.
(3) Use fine point tips only when necessary. The plating on fine precision
tips is less durable than the plating on blunter tips.
(4) Do not use the tip as a prying tool. Bending the tip will cause the plating
to crack, shortening tip life.
(5) Use the minimum activation flux necessary to do the job. Higher
activation flux is more corrosive to the tip plating.
(6) Extend tip life by switch the system off when not in use.
(7) Don’t apply pressure to the tip. More pressure does not equal more heat.
To improve heat transfer, use solder to form a thermal bridge between
the tip and the solder joint.
Ⅸ. Error messages
Various error messages will be displayed when there is something wrong with the
unit.
Sensor error:
If there is a failure in the sensor or anywhere in
the sensor circuit, “S-E” will be displayed and power to the
soldering iron handle will be cut off.
Heater error:
If power cannot be sent to the soldering iron, the
display window will show “H-E”. This indicates the possibility of a
heater malfunction.
Ⅹ. Check and Replace the Soldering Iron
When there is something wrong with the soldering iron, you can check and test it.
If it is broken, replace the broken element.
To Next Page
Loading...
Need help?
General
