EasyManuals Logo
Home>Quicksilver>Boat>Activ 555

Quicksilver Activ 555 User Manual

Quicksilver Activ 555
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #38 background imageLoading...
Page #38 background image
Quicksilver 555OP— Electrical Systems
26
1. DC Electrical System
The DC electrical system is powered by a single baery, and is kept charged by the engine driven
alternator.
2. Baery
Quicksilver® recommends AGM type starng or a deep cycle baery for you boat. The baery must
meet the minimum capacity required by the engine manufacturer. Refer to your engine owner’s
manual for exact baery requirements.
To remove the baery cables:
1. Turn o all items drawing power from the baery.
2. Turn the baery switch to the OFF posion.
3. Remove the negave cable rst, then the posive cable.
To replace the cables, install the posive cable rst, then the negave cable.
3. Baery Box
The baery box, located in the a bilge, houses the baery. This box can be accessed via the hatch
located in the a lounge storage tub. The baery can be installed or removed by loosening the strap
and removing the lid on the baery box. It should always be installed and secured within the baery
box installed on your boat. This will ensure that the baery will not move around while the boat is
underway.
4. Baery Switch
Your vessel is equipped with a baery switch to control the delivery of DC power from the baery.
The baery switch panel is located in the a lounge storage tub. When you turn the baery switch to
the ON posion, power is provided from the baery to the enre boat. To turn on power, rotate the
switch clockwise 90 degrees to the ON posion.
Never use an open ame in the baery storage area. Avoid
striking sparks in the baery area.
Always disconnect the baery before doing any work on the
electrical system. Never turn o the baery switches or
disconnect the baery cables while the engines are running.
The bilge pump sll draws power from the baery, even if
the switch is set to OFF. This is especially important for the
bilge pump, so that it can operate anyme excess uid
accumulates in the bilge, which can occur when the boat is
docked and unaended.
Never work on the electrical system while the system is
energized. Never leave the cra unaended with the
electrical system energized.
Baery Switch Operaon
OFF Posion
ON Posion

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Quicksilver Activ 555 and is the answer not in the manual?

Quicksilver Activ 555 Specifications

General IconGeneral
BrandQuicksilver
ModelActiv 555
CategoryBoat
LanguageEnglish

Related product manuals