32
Uninstalling the CUBE
1 Switch o the CUBE
Switch o the CUBE using the display. Do not remove the
power cable.
2 Empty the CUBE
Open the tap for sparkling water (push-turn) and close
it when only CO
₂
gas comes out. The sparkling water
may need to be activated two times before the CUBE is
completely empty.
3 Shut down the CUBE
Close the shut-o valve by turning the red knob. Verify
that the system has been depressurised by activating the
chilled water (push-wait-turn). There should be no more
water owing from the tap.
4 Disconnect the CO
₂
cylinder
Unscrew the CO
₂
cylinder from the pressure reducing valve.
A little gas may escape here.
(in case of service)
2
4
1
3
To Next Page
Loading...
