Qviart UNIC User Manual

9
5.2 Favorites / Radio Favorites
Menu->EDIT CHANNEL-> Favorites/Radio Favorites
1. Press the color button directly to add or remove the highlighted channels to or out of the corresponding
favorite group.
2PresstheEXIT button to exit the menu and save it.
5.3 Sort Channels
Menu-> EDIT CHANNEL ->Sort Channels
Highlight the option you want and press the OK button to sort the channel list. You can sort by Alphabet,
Transponder, FTA To CAS, Default, Favor, FTA To CAS+ Alphabet, Provider and Service ID.
5.4 User Channel List
User Channel List allows you to save or load all the data and settings.
1. Menu->EDIT CHANNEL -> User Channel List->Save User Data
2. Menu->EDIT CHANNEL -> User Channel List->Load User Data
6. Settings
Tip: Input the default password.
6.1 System Settings
Menu->SETTINGS->System Settings
1. Menu Language: Set the menu language.
2. Audio1: Set the preferred audio language.
3. Audio2: Set the sub-prime audio language.
4. Subtitle Language: Set the subtitle language.
5. EPG Lang uage: Set the EPG language.
6. TXT Langu age:SettheTXTlanguage.
7. Scart Output㧦While the HDMI Mode is set to 576i or 480i
mode, you can change the scart output mode between CVBS and RGB mode.
8.Auto Channel Selection: If you set ON, it will play automatically the highlighted channel. If you set OFF, you
should press the OK button to play it.
9. Auto Exit CH List: If you set ON, it will disappear when you press OK on a Highlighted channel. If you set
OFF, the channel list will disappear.
10. Recall List: If you set ON, when you press Recall button of RCU you can get the recall list. If you set OFF,
you can go back to the last program you have selected.
11. Low Power Standby: If you set ON, when standby the power consumption is lower. If you set OFF,when
standby the power consumption is same as power on.
12.Front Panel Light: Set the brightness of the LED.
13.Network auto update: set network auto update or not.
6.2 OSD Setup
Menu->SETTINGS->OSD Setup
1. Menu Transparency: Set the transparency of all menus.
2. TXT Transparency: Set the transparency of teletext.
3. Display Mode: Set the HD format between 1080p, 1080i,
720p, 576i or 576p.
4. TV Type:SettheTVTypeonPAL/NTSC/Auto state.
5. Screen Mode: Set the display format according to the screen
ratio.
6. OSD Timeout: Set the display time of the program

Qviart UNIC Specifications

General

Brand	Qviart
Model	UNIC
Category	Receiver
Language	English