This STB has been designed and manufactured to satisfy the international safety standards. Please read the
following safety precautions carefully before operating this receiver.
Main Supply:
Before operating, please check the units operating voltage is 90~250V AC 50/60Hz.
Overload:
Do not overload a wall outlet, extension cord or adapter, neither use damaged power cord or touch it with wet
hand as this may result in electric shock.
Liquid:
The receiver shall not be exposed to dripping or splashing water, and that no objects filled with liquids, such as
base, shall be placed on the apparatus.
Ventilation:
Keep the slots on top of the receiver uncover to allow sufficient airflow to the unit. Do not put the receiver on
soft furnishings or carpets. Do not expose the receiver to direct light or do not place it near a heater or in
humid conditions. Do not stack other electronic equipment on top of the receiver.
Cleaning:
Plug out the receiver from the wall outlet before cleaning. Clean the receiver by a soft cloth or mild solution of
washing-up liquid (no solvents).
Connection:
Disconnect the receiver from the mains when you connect it to satellite LNB or disconnect it from LNB. Failure
would possibly cause damage to the LNB.
Location:
Put the receiver indoor in order to avoid lightening, raining or sunlight.
Uncover:
Do not remove the cover, to reduce the risk of electric shock. Contact qualified and licensed service personnel
to repair the receiver, or contact your dealer.
1. Reference
1. Accessories
ǂǂUsers manual
ǂ Batteries
ǂRemote Control Unit
Figure 1.Accessories
To Next Page
Loading...
Need help?
General
