RADWAG PS/X series User Manual

- 10 -
4.2. Unpacking
Carefully remove the balance from its packaging, remove the plastic, foil and
cardboard transport protective elements and gently place the balance in its intended
place of use. Assemble the weighing pan, and other elements according to below
scheme:
Assembling components of a balance with measuring accuracy 10 mg:
- Remove the protective tape securing
the mass spring on one of the rubber
mandrels (2),
- Assembly the weighing pan (1) onto
the rubber mandrels (3),
- On assembling check whether the
weighing pan is placed firmly on the
rubber mandrels.
Assembling components of a balance with measuring accuracy 1mg:
- Remove the protective tape securing the
mass spring on one of the rubber
mandrels (3),
- Assembly the weighing pan (2) onto the
rubber mandrels (4),
- Assembly the anti-draft shield (1) onto
the top housing of the balance,
- On assembling check whether the
weighing pan is placed firmly on the
rubber mandrels.
Fig. 1. Assembling components of a balance PS/X series

RADWAG PS/X series Specifications

General

Brand	RADWAG
Model	PS/X series
Category	Scales
Language	English