Programming the Controller, continued
20
2. Use the arrow keys to select the station.
3. Press MAN START/ADV.
The length of time to water flashes, indicating
that it is ready to be set.
4. Use the arrow keys to set the maximum watering
time from 1 to 99 minutes.
5. Press MAN START/ADV .
The length of time to soak flashes, indicating that
it is ready to be set.
6. Use the arrow keys to set the minimum soak time
from 1 to 99 minutes.
7. If you want to set Cycle + Soak
TM
for another
station, press MAN START/ADV again.
8. When you have finished setting Cycle + Soak
TM
,
return the dial to AUTO.
The controller returns to the time of day display.
Setting the Water Budget
The water budget feature allows you to increase or
decrease a program’s watering time in increments of
1% without having to reset the timing for each
station in the program. You can set the budget for
0% to 300%. You can use the 0% setting to shut a
program down temporarily.
To set the water budget,
1. Rotate the dial to WATER BUDGET.
The display shows the program and the water
budget percentage.
2. Press PGM until the program you want is
displayed.
3. Use the arrow keys to set the percentage.
4. Return the dial to AUTO.
The controller returns to the time of day display.
The default percentage for all programs is 100%.
When the water budget for a program is set to
other than 100%, WATER BUDGET will show in
the display whenever that program is selected.
Note: The maximum watering time with WATER
BUDGET is 16 hours.
To Next Page
Loading...
Need help?
General
