4.3 Connections overview
Use the following information to help you identify the connections
on your product.
Connector Connector type Connects to:
CPT-60 / CPT-70 /
CPT–80 Transducer
and display power
Dragony display
CPT-100 /
CPT-110 / CPT-120
Transducer
Sonar module or
compatible multifunction
display.
4.4 Transducer cable connection
The transducer can be connected directly to a DownVision sonar
module or a DownVision variant multifunction display.
Follow the Cables and Connections chapter of the manual
that accompanied your sonar module or DownVision variant
multifunction display to make the appropriate connections.
Making connections
Follow the steps below to connect the cable(s) to your product.
1. Ensure that the vessel's power supply is switched off.
2. Ensure that the device being connected to the unit has
been installed in accordance with the installation instructions
supplied with that device.
3. Ensuring correct orientation, push the cable connector fully
onto the corresponding connector on the unit.
4. Turn the locking collar clockwise to secure the cable.
Transducer cable extension
For some installations it may be necessary to extend the
transducer cable.
• Refer to
Chapter 11 Spares and accessories for a list of
suitable transducer extension cables.
• Raymarine recommends a maximum of one cable extension
for any single transducer cable.
• For best performance, keep all cable lengths to a minimum.
Cables and connections
21
To Next Page
Loading...
Need help?
General
