To Next Page

To Previous Page

Re S.p.A. WG251 SKB-B RESMART

Rev. 05/15 3/25

 Application without a micrometer bar

 Fit the slide onto the sensor holder bar so that the sensor is in the required position

according to where the material will run.

 Tighten the knob located under the sensor.

2) Fasten the WG251 SKB-B RESMART webguide to the machine structure using the 4 holes on the

external box support table using 4 x M6x10 screws (not supplied with the webguide).

The direction of the guide should be fixed according to the direction the material will run in (the

arrow on the frame of the webguide indicates the material feed direction).

Check that the infeed and outfeed machine rollers are parallel and on the same plane as the

webguide rollers.

Assemble the guide observing the safety distances between the webguide and the rest of the

machine, as stipulated in current normatives

Caution! It is important to secure the webguide before connecting it up electrically;

when making the electrical connections follow the instructions in the following section.

SU m-25 sensor

Sensor slide

Knob for fixing

Sensor holder bar

Fixing holes

for screw M6x10

Re WG251 SKB-B RESMART User Manual

Questions and Answers: