REPLIGEN XCell ATF Series User Manual

XCell
TM
ATF System with C410:V4B Controller User Guide
59
Figure 9: Filtration Assembly Prepared for Autoclaving
8.1.5 Close all unprotected ports.
8.1.6 Depending on the size/configuration of the autoclave, the Filtration Assembly can be placed
inside the autoclave either vertically or at an angle if necessary. Most autoclaves are not
sufficiently tall for vertical placement.
8.1.7 Use caution during the procedure so not to damage attached parts or tubing. Avoid kinking
or stressing attached tubing.
8.2 Autoclave Cycle
8.2.1 The Xcell ATF systems have been designed to be sterilized using an autoclave.
The XCell ATF System Filter Preparation and Autoclave Guide provides detailed
guidance on the entire procedure including the recommended filter integrity test
procedures and specifications. The features of the recommended cycle are intended
to ensure that the system will be effectively sterilized and that there is minimal
thermal stress imposed on the hollow fiber cartridge that could lead to integrity
failures.

REPLIGEN XCell ATF Series Specifications

General

Brand	REPLIGEN
Model	XCell ATF Series
Category	Laboratory Equipment
Language	English