IKONIC Tankless Water Heater Service Manual
69
HOW TO REMOVE COMPONENTS
3.6 WATER CONTROL VALVE
NOTE: Before removing water inlet connec-
tion, turn off water to the water heater by
closing the shut off valve.
1. Remove user interface from the water heater.
NOTE: To remove the interface , refer to sec-
tion “3.13 Display".
2. Remove water control wiring harness from the
control board (connector “G”) and remove the two
white Molex connectors located rear of the user in-
terface.
3. Remove the four screws and two flange bracket.
Then, remove water inlet pipe and bypass pipe.
4. Remove quick fastener connected to check valve.
NOTE: for recirculation model, remove quick
fastener connected to water inlet connection.
5. Remove quick fastener connected to bypass valve.
Bypass Valve
Water Control Valve
To Next Page
Loading...
Need help?
General
