Setting Paper on the Bypass Tray
This section gives instructions for setting paper on the bypass tray.
For details about paper size and paper type, see "Paper Size and Paper Type", About This Machine.
• Paper sizes that can be loaded onto the bypass tray are 90 - 305 mm (3.55 - 12 in.) vertical, and
148 - 600 mm (5.83 - 23.62 in.) horizontal.
• When paper larger than 600 mm (23.62 in.) in length is used, the paper may become wrinkled, may
not be fed into the machine, or may cause paper jams.
• The machine can automatically detect the following sizes as regular size copy paper:
• A3 , B4 , A4 , B5 , A5 , B6 , A6
• 11" 17" , 10" 15" , 8" 13" , 8
1
/
2
" 11" , A5 , B6 , A6
• If you want to use the size of paper other than the above, be sure to specify the size.
• The following functions are disabled when printing from the bypass tray:
• Duplex/Booklet printing (when the optional Finisher SR790, Finisher SR3000, or SR3050 is
installed)
• Auto Tray Select
• Auto Tray Switching
• Rotating Collate
• Staple (when the optional Finisher SR790, Finisher SR3000, or SR3050 is installed)
• Punch (when the optional Finisher SR3000 and Punch Unit are installed)
Printing onto paper with specific orientation
When printing onto paper that has specific orientation requirements, such as envelopes or letterhead
paper, be sure to set as the followings:
• If the paper feed orientation is , insert paper print side down in the bypass tray, and set the
bottom edge of the paper toward the machine.
• If the paper feed orientation is , insert paper print side down in the bypass tray, and set the
bottom edge of the paper toward you.
To print on paper that is set in the opposite position to either of the correct positions described above,
rotate the print image 180 degrees using the printer driver. For details, see the printer driver Help.
15
To Next Page
Loading...
Need help?
General
