SP1100S/Aficio SP1100S
- 20 -
4 - Parameters/Setup
Parameters/
Setup
You can setup your machine as you like depending on the
use. You will find in this chapter description of the
functions.
You can print the functions guide and the available setup
of your multifunction machine.
Language
This setting enables you to choose the menu language of
your choice. By default, the multifunction machine is set
to English.
To select the language:
203 - SETUP / GEOGRAPHICAL / LANGUAGE
1 Press , enter 203 using the keypad. Confirm with
OK.
2 Select the required language using and ,
then press the OK button to confirm.
3 To exit this menu, press .
Technical Parameters
As delivered your machine is preset by default. However,
you may adjust it to meet your requirements by resetting
the technical parameters.
To set the technical parameters:
29 - SETUP / TECHNICALS
1 Select the desired parameter and confirm with OK.
2 With the buttons
or , modify the parameter
settings by following the table below and press OK.
Note
Your machine is continuously being
updated, new functions are regularly
made available.
Contact your Dealer to check if
firmware updates are available for your
machine (see Firmware update,
page 41).
P a r a m e t e r S i g n i f i c a t i o n
8 - Eco energy Choosing the printer standby delay: the
printer will switch to standby after a
delay (in minutes) of NON-operation or
during the period of time of your
choice.
Note: you can also access this
parameter by pressing the key
from the idle screen.
79 - Toner
Management
This parameter helps you manage the
consumable. When set to W
ITH [0-
10%], you can only replace the toner
cartridge when the toner has reached
the threshold.
If ever you need to replace the toner
cartridge before the toner near end, set
the parameter to W
ITH [0-100%] and
proceed with the toner cartridge
replacement (see chapter
Maintenance, page 38).
Disabling the toner management
(parameter set to W
ITHOUT) is strongly
not recommended as you may loose
faxes and spill toner in your print
mechanism. When set to W
ITHOUT, the
screen displays T
ONER ? %.
80 - Toner save Makes printing lighter to save toner
cartridge ink.
91 - Printer error
timeout
Time-out before document being
printed is deleted following a print error
in PC print mode.
92 - Printer wait
timeout
Wait time-out for data from PC before
the task is deleted in PC print.
93 - Replace format Page format change. This parameter
allows you to print a LETTER format
document on A4 pages using the
LETTER/A4 setting.
To Next Page
Loading...
Need help?
General
