252
7
Appendices
The camera has a hot shoe, allowing you
to attach an external flash (available in
stores).
1
Close the flash cover (GP.23).
2
With the camera and external
flash powered off, attach the
external flash to the hot shoe.
3
Turn on the camera, turn the mode dial to A or M, and
set the aperture value (GP.87, 89).
4
Set the ISO sensitivity to a value other than [Auto]
(GP.146).
5
Turn on the external flash, turn its mode to Auto, and
set the aperture value and ISO sensitivity to the same
values on the camera.
• Be sure to turn off the external flash before detaching the external
flash from the camera.
Caution------------------------------------------------------------------------------------------
• Camera shake may occur when using slower shutter speeds.
• When using a commercially-available external flash, make sure the flash has the
following specifications.
• It must not have a signal terminal other than an X contact.
• The polarity of the X contact must be positive (+).
• The voltage of the X contact must not exceed 20V.
• You cannot use the internal flash when an external flash is attached as this can cause
injury or damage.
• You cannot use the LCD viewfinder when an external flash is attached.
• Irrespective of flash setting, a flash ON signal is output to the X contact of the hot shoe.
To stop an external flash, use a switch on the flash.
• Exposure may not be appropriate even when the aperture value and ISO sensitivity
of the external flash are the same as those of the camera. If so, change the aperture
value and ISO sensitivity of the flash.
• Use an external flash with a lighting angle that covers the angle of view of the shooting
lens.
• Use an external flash basically at a distance where the internal flash is not adequate
(long distance). Shooting at a short distance with an external flash may result in over-
exposure of the subject.
Using the External Flash
Hot shoe
To Next Page
Loading...
Need help?
General
Weight and Dimensions
