Loading Paper into the Bypass Tray
Use the bypass tray to use OHP transparencies, adhesive labels, translucent paper, and paper that
cannot be loaded in the paper trays.
• The maximum number of sheets you can load at the same time depends on paper type. Do not
stack paper over the limit mark. For the maximum number of sheets you can load, see page 144
"Recommended Paper Sizes and Types".
1. Open the bypass tray.
2. Load the paper face down until you hear the beep.
3. Align the paper guides to the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
When loading paper into the bypass tray of a Type 5 machine, align the paper guides to the
paper, and then the machine will automatically make fine adjustments to the position of the side
fences so that they exactly align with the size of the paper you loaded.
• When you use the bypass tray, it is recommended to load the paper in orientation.
9. Adding Paper and Toner
132
To Next Page
Loading...
Need help?
General
