Message Causes Solutions
"An error occurred while
processing an Unauthorized
Copy Prevention job. The
job was cancelled."
The resolution is set to a
value less than 600 dpi
when [Unauthorized Copy
Prevention] is specified.
On the printer driver, set the resolution
to 600 dpi or higher, or deselect
[Unauthorized Copy Prevention].
"Collate has been
cancelled."
Collate was canceled. Turn off the power, and then back on
again. If the message appears again,
contact your service representative.
"Exceeded the maximum unit
count for Print Volume Use.
The job has been
cancelled."
The number of pages the
user is permitted to print has
been exceeded.
For details about print volume use
limitation, see Security Guide .
"Receiving data failed." Data reception was aborted. Resend the data.
"Sending data failed." The machine received a
command to stop
transmission from the printer
driver.
Check if the computer is working
correctly.
"The selected paper size is
not supported. This job has
been cancelled."
Job reset is automatically
performed if the specified
paper size is incorrect.
Specify the correct paper size, and
then print the file again.
"The selected paper type is
not supported. This job has
been cancelled."
Job reset is automatically
performed if the specified
paper type is incorrect.
Specify the correct paper type, and
then print the file again.
When there is a problem with the print settings
Message Causes Solutions
"Booklet/Half Fold Error" The job was canceled
because you specified
invalid settings for saddle
stitching or half fold.
Check the settings for saddle stitching or
half fold.
"Classification Code is
incorrect."
The classification code has
not been entered, or the
classification code has
been entered incorrectly.
Enter the correct classification code.
10. Troubleshooting
192
To Next Page
Loading...
Need help?
General
