15
INSTALLATION
2.3 Moving and removing the packing
9
Wear suitable personal protection equipment when moving
the boiler and removing the packing. Only use lifting equip-
ment that is suitable for the weight involved.
The product can be moved in two ways:
− using a hoist of suitable lifting capacity;
− using a fork lift of suitable lifting capacity.
Two lifting points (A) are provided at the top of the boiler body for
use with a hoist.
Proceed as follows to move the boiler and remove the packing:
− Move the boiler to its place of installation, using equipment
of suitable lifting capacity;
− Remove the protective lm;
− RTC 3000 and RTC 4000 boiler bodies are secured to their
pallets by 6 screws while the RTC 5000-RTC 10000 models
are not placed on a pallet;
− Unscrew the screws securing the boiler to the pallet (mod-
els RTC 3000-RTC 4000) and position the boiler at its place
of installation
0
Do not dispose of packaging material into the environment, or
leave it within the reach of children, since it can become a po-
tential hazard. Dispose of packaging material in compliance
with applicable legislation.
− for lifting using a rigging crane, use only the lifting provi-
sions supplied
− when lifting the boiler using chains, make sure that at least
two chains are load-bearing. Lift up very carefully
− maintain less than a 45 degree angle with the vertical
when lifting the boiler with chains or cables.
− the rigging crane must be operated by trained personnel.
9
WARNING: Risk of injury from carrying heavy loads and inade-
quately securing loads for transport.
− Use suitable means of transportation, e.g. several pallet
trucks, a forklift truck, crane or heavy duty rollers
− secure the load against falling.
To Next Page
Loading...
Need help?
General