Rigol DS6104 Performance Verification Guide

Chapter 2 Performance Verification Test RIGOL
DS6000 Performance Verification Guide
2-21
2. Enable Fluke 9500B and set its impedance to 50 Ω.
3. Output a fast edge signal with 150 ps rise time and 1.2 Vpp amplitude via Fluke 9500B.
4. Configure the oscilloscope:
1) Press CH1 in the vertical control area (VERTICAL) at the front panel to enable CH1.
2) Press CH1  Probe  Ratio to set the probe attenuation ratio to “1X”.
3) Press CH1  Input to set the input impedance to 50 Ω.
4) Press ACQ  Sampling to select “Real Time”.
5) Rotate VERTICAL SCALE to set the vertical scale to 200 mV/div.
6) Rotate HORIZONTAL SCALE to set the horizontal time base to 500 ps (the setting
value is different for different model of oscilloscope under test; please refer to
Table 2-3).
Table 2-3 Horizontal Time Base Setting Value for the Oscilloscope under Test
Model Horizontal Time Base
DS610X 500 ps/div
DS606X 1 ns/div
7) Rotate VERTICAL POSITION and HORIZONTAL POSITION respectively to set
the vertical position and horizontal position to appropriate values.
8) Rotate TRIGGER LEVEL to adjust the trigger level to the middle of the screen.
5. Observe the screen of the oscilloscope. Press CURS  Mode “Manual” to enable the manual
cursor function. Measure the zero point offset using manual cursor measurement and record the
measurement result.
6. Keep the other settings of the oscilloscope unchanged and set the vertical scale to 500 mV/div.
7. Output a fast edge signal with 150 ps rise time and 3 Vpp amplitude via Fluke 9500B.
8. Measure the zero point offset according to the above method and record the test result.
9. Turn off CH1. Test CH2, CH3 and CH4 respectively according to the method above and record the
test results.

Rigol DS6104 Specifications

General

Brand	Rigol
Model	DS6104
Category	Test Equipment
Language	English