Rittal CMC III online comfort handle VX 5
2 Safety instructions
EN
2 Safety instructions
2.1 General safety instructions
Please observe the subsequent general safety instruc-
tions for the installation and operation of the system:
– Use only original Rittal products or products recom-
mended by Rittal in conjunction with the comfort
handle.
– Please do not make any changes to the comfort
handle that are not described in this manual or in the
associated manuals.
– The operational safety of the comfort handle is only
warranted in case of use as intended and according
to the rules. The technical specifications and limit
values stated must not be exceeded under any cir-
cumstances. In particular, this applies to the specified
ambient temperature range and IP degree of protec-
tion.
– The comfort handle housing must not be opened.
The unit does not contain any parts that need servic-
ing.
– Operating the system in direct contact with water,
aggressive materials or inflammable gases and va-
pours is prohibited.
– Other than these general safety instructions, ensure
you also observe the specific safety instructions
when the tasks described in the following chapters
are performed.
– When closing the handle, take care not to insert your
finger between the handle lever and the comfort han-
dle housing, as it could become trapped.
2.2 Service and technical sta
– The mounting, installation, commissioning, mainte-
nance and repair of this unit may only be performed
by qualified mechanical and electro-technical trained
personnel.
– Only properly instructed personnel may work on a
unit while in operation.
To Next Page
Loading...
Need help?
General
