Important User Information
Solid state equipment has operational characteristics differing from those of
electromechanical equipment. “
Safety Guidelines for the Application, Installation
and Maintenance of Solid State Controls
” (Publication SGI-1.1 available from
your local Allen-Bradley Sales Office or online at
http://www.ab.com/manuals/gi
)
describes some important differences between solid state equipment and
hard-wired electromechanical devices. Because of this difference, and also
because of the wide variety of uses for solid state equipment, all persons
responsible for applying this equipment must satisfy themselves that each intended
application of this equipment is acceptable.
In no event will the Allen-Bradley Company be responsible or liable for indirect or
consequential damages resulting from the use or application of this equipment.
The examples and diagrams in this manual are included solely for illustrative
purposes. Because of the many variables and requirements associated with any
particular installation, the Allen-Bradley Company cannot assume responsibility or
liability for actual use based on the examples and diagrams.
No patent liability is assumed by Allen-Bradley Company with respect to use of
information, circuits, equipment, or software described in this manual.
Reproduction of the contents of this manual, in whole or in part, without written
permission of the Allen-Bradley Company is prohibited.
Throughout this manual we use notes to make you aware of safety considerations.
Attentions help you:
•
identify a hazard
•
avoid the hazard
•
recognize the consequences
Important:
Identifies information that is especially important for successful
application and understanding of the product.
DriveExplorer, DriveTools32, and SCANport are trademarks of Rockwell Automation.
PLC is a registered trademark of Rockwell Automation.
ControlNet is a trademark of ControlNet International, Ltd.
DeviceNet is a trademark of the Open DeviceNet Vendor Association.
!
ATTENTION:
Identifies information about practices or circumstances
that can lead to personal injury or death, property damage, or economic
loss.
Shock Hazard
labels may be located on or inside the drive to alert
people that dangerous voltage may be present.
Burn Hazard
labels may be located on or inside the drive to alert
people that surfaces may be at dangerous temperatures.
userman.book Page 2 Friday, June 21, 2002 2:48 PM
To Next Page
Loading...
Need help?
General
