Rockwell Automation Publication CC-QS034C-EN-P - March 2015 31
System Validation Chapter 2
Follow these steps to modify these settings in the default Connected Components Workbench project.
1. From the Connected Components Workbench software, from the File menu, choose Open.
2. From the Connected Components Accelerator Toolkit (CCAT), choose the default
‘Starting_PFx_Modbus_r8.ccwsln’ project or the CCAT version 2.0 generated project. Use controller type change, if
necessary, to match your Micro800 controller catalog number. Refer to software help for instructions on controller
type change.
3. In the Project Organizer, double-click the controller icon. This example shows a Micro850 controller.
To Next Page
Loading...
Need help?
General
