Publication 2711P-UM001I-EN-P - December 2008 39
Installation Chapter 2
Mount the 700 to 1500
Terminal in a Panel
Mounting clips secure the terminal to the panel. The number of clips
you use (4, 6, or 8) varies by terminal type.
Follow these steps to mount a 700 to 1500 terminal in a panel.
1. Cut an opening in the panel by using the panel cutout shipped
with the terminal.
2. Make sure the terminal sealing gasket is properly positioned on
the terminal.
This gasket forms a compression-type seal. Do not use sealing
compounds.
3. Install the legend strips before installing the terminal if you are
using keypad legend strips on keypad terminals.
Be careful not to pinch the legend strip during installation.
4. Place the terminal in the panel cutout.
ATTENTION
Disconnect all electrical power from the panel before making
the panel cutout.
Make sure the area around the panel cutout is clear.
Take precautions so metal cuttings do not enter any
components already installed in the panel.
Failure to follow these warnings may result in personal injury or
damage to panel components.
Sealing Gasket
To Next Page
Loading...
Need help?
General
