Before you start playing
16
r
FR-3x V-Accordion
Installing and removing batteries
Your FR-3x has a compartment that contains a special
holder unit into which you can install 10 rechargeable
AA-type Ni-MH batteries (not supplied). You can there-
fore play your instrument without connecting the sup-
plied adapter.
1.
Switch off the FR-3x.
2.
Remove the cushion located between the
treble keyboard and the bellows.
3.
Remove the cover from the FR-3x’s battery
compartment by pressing the two tabs and
lifting the cover.
You should now see a tab that allows you to remove
the battery case:
4.
Use the tab to pull the battery case out of
the compartment and turn the case around.
The battery case is connected to the FR-3x by means
of a cable with a padded connector strip. You can
disconnect the cable from the battery case by pulling
off the padded connector strip.
This is unnecessary if you manage to install (or
remove) the batteries without disconnecting the
connector strip.
5.
Insert 10 rechargeable AA-type Ni-MH bat-
teries into the compartment (5 on either
side), taking care to orient them in accor-
dance with the “+” and “–” indications.
6.
Insert the battery case with the 10 (5 + 5)
batteries into the compartment.
7.
Close the FR-3x’s battery compartment and
re-install the cushion.
NOTE
Though it is perfectly possible to use rechargeable batter-
ies, be aware that they cannot be recharged simply by leav-
ing them in the FR-3x’s compartment and connecting the
adapter. You will need an external charging unit.
FR-3x GB.book Page 16 Thursday, March 18, 2010 6:37 PM
To Next Page
Loading...
Need help?
General
