Effect Parameters
46
Effect Parameters
This explains about the parameters of the effects built into the JX-08.
CHORUS&MFX parameters
Here’s how to configure the effects.
Use the Type parameter to select an effect. The parameter types that you can configure depend on the effect you’ve selected. For
details on the parameters you can set, refer to the individual pages that explain each effect.
Type parameter (Type )
Cho1
12.1.1. JUNO-106 CHORUS(P.46)
Cho2
Cho3
dLy1
12.1.4. TimeCtrlDly(P.48)
dLy2
12.1.5. 2Tap PanDly(P.48)
dLy3
R.dLy
12.1.7. Reverse Dly(P.51)
Od
Fv__
drU
Bit.C
12.1.11. Bit Crusher(P.53)
L.CNp
PhA1
PhA2
12.1.14. M StagePhsr(P.54)
FiLt
12.1.15. SuperFilter(P.54)
Ptc1
12.1.16. PitchShiftr(P.55)
Ptc2
12.1.17. 2V PShifter(P.56)
JUNO-106 CHORUS
Parameter Value Explanation
type
Cho1
Models the chorus section of the Roland JUNO-106.
[2]
Sľ
Off,
On
Turns the effects on/off.
[3]
NodE
1
The effect produced when pressing chorus button [I] on a JUNO-106.
2
The effect produced when pressing chorus button [II] on a JUNO-106.
1_2
The effect produced when pressing both chorus button [I] and [II] on the JUNO-106
at the same time.
JX1
The effect produced in chorus mode 1 on the JX-8P.
JX2
The effect produced in chorus mode 2 on the JX-8P. Offers a thicker sound than
chorus mode 1.
noiS
0
127
Volume of noise produced by the chorus effect
Volume balance between the effect sound and dry (original) sound