Effect Parameters
55
Parameter Value Explanation
[1]
tyPe FiLt
This is a filter with an extremely sharp slope (attenuation
characteristics). The cutoff frequency can be varied cyclically.
Sľ
Off
On
Turns the effects on/off.
[3]
tyPE
Frequency range that passes through each filter
LPF
Frequencies at or below the cutoff
bPF
Frequencies in the region of the cutoff
HPF
Frequencies at or above the cutoff
notc
Frequencies other than the region of the cutoff
[4]
SLoP
Filter slope (attenuation characteristics; amount of attenuation per octave)
-12
-24
-36
[5]
C.OFF
0
127
Cutoff frequency of the filter
Increasing this value raises the cutoff frequency.
[6]
rESo
0
100
Increasing this value emphasizes the region near the cutoff
[7]
GAin
0
12 (dB)
Amount of boost for the filter output
[8]
Nod
Off
On
On/off switch for cyclic change
[9]
Nod.ľ
These waves control how the cutoff frequency changes.
tri
Sqr
Sin
Saľ1
Saľ2
[10]
Sync
Off
On
When this is ON, the effect synchronizes with the tempo of the
rhythm.
“8.2.1. Tempo Settings(P.28)”
tiNE
0.05
10.00
[12]
notE
“12.1.18. About note
values(P.57)”
dePt
0
127
[14]
AtK
0
127
Speed at which the cutoff frequency changes
The Nod.ľ parameter is effective when using a square wave or
sawtooth wave (upward or downward).
[15]
LEU
0
127
You can also press a step button to select the parameter items.
PitchShiftr
tyPe
Ptc1
Sľ
Off
On
Turns the effects on/off.
CrS
-24
12
Adjusts the pitch of the pitch-shifted sound in semitones.
FinE
-100
100
Adjusts the pitch of the pitch-shifted sound in 2-cent steps.
To Next Page
Loading...
Need help?
General
