Effectivity: 912 Serie
Edition 4 / Rev. 0
BRP-Rotax Page 3-7
November 01/2016
ATTENTION
Activate starter for maximum of 10 seconds only (without inter-
ruption), followed by a cooling period of 2 minutes.
Step Designation Procedure
7 As soon as engine
runs
adjust throttle to achieve
smooth running at approx.
2500 rpm.
8 Oil pressure check if oil pressure has ris-
en within 10 seconds and
monitor oil pressure. In-
crease of engine speed is
only permitted at steady oil
pressure readings above 2
bar (30 psi).
ATTENTION
At an engine start with low oil temperature, continue to observe
the oil pressure as it could drop again due to the increased flow
resistance in the suction line. The number of revolutions may
be only so far increased that the oil pressure remains steady.
Step Designation Procedure
9 Starting carb (choke) de-activate
To observe
Reduction gear with shock absorber
ATTENTION
Since the engine comprises a reduction gear with shock ab-
sorber, take special care of the following:
Step Procedure
1 To prevent impact load, start with throttle lever in idle po-
sition or at the most up to 10% open.
2 For the same reason, wait for around 3 sec. after throt-
tling back to partial load to reach constant speed before
re-acceleration..
3 For checking the two ignition circuits, only one circuit
may be switched off and on at a time.
To Next Page
Loading...
Need help?
General
