Royal Enfield Bullet User Manual

2. CIeaning/Replacement of Oil Filter
Element
- Oil Feed and Return Filters
I
The oiI filter is located in the timing cover
immediately below the oil pumps. The felt element
should
be taken out and washed in petrol after
the first 800 Kms. and subsequently, every 4.000
Krns. Fit a new element every 8,000 Kms.
The filter element can be removed by
unscrewing the nut holding the end cap in
position. When re-assembling the filter take care
that no grit or other foreign matter is
stlcldng to
it. After replacing the Alter element it is essential
to nm the engine at idling for about five minutes
to ensure that oil reaches the big end.
If the tfming
cover has been removed, fill the filter chamber
with clean
oil before replacing the cover.
The feed and
return filters are fked on the
drain plugs in oil sump and crank case. These
can be cleaned by rinsing
in a solvent and during
reassembly ensure the filters are not twisted.
VALVE TIMING MARKS
FELT WASHER -4 I
METAL WASHER
SPRING
3. Overhauling of Oil feed and return Pumps
-Remove the timing cover.
-Remove the end covers from both pumps.
-Remove the pump discs and plungers.
-Remove the pump spindle which
can be pulled out only from the front or return pump end.
--Check the fit of the plungers
in the pump discs which should be &ding fit and should be
able to be moved
in and out by hand.
011 FEED d RETURN PUMPS ASSK
W"" PLUNGER FEED

Royal Enfield Bullet Specifications

General

Brand	Royal Enfield
Model	Bullet
Category	Motorcycle
Language	English