Hardware Installation and Reference Guide Starting and Configuring the Enterprise-class Router
23
UBI: number of PEBs reserved for bad PEB handling: 2
……
Starting vlan_terminal.elf... [ OK ]
Starting webservice.elf...
Starting webservice.elf... [ OK ]
html decompress.
html decompress. [ OK ]
Starting php-fpm...create /var/run/php-fpm.pid done...
Starting php-fpm...create /var/run/php-fpm.pid done... [ OK ]
WARNING: pgstat wait timeout
Starting Nginx...
Starting Nginx... [ OK ]
Starting newcmd v_tty...
Starting newcmd v_tty... [ OK ]
Press RETURN to get started
WARNING: pgstat wait timeout
Ruijie>
After the startup, you can configure the enterprise-class router.
Instruction
The above startup information is for reference only. The router with different hardware configurations or
software versions will display different startup information.
In case of using the enterprise-class router for the first time, you are advised to use a configuration
function to configure the basic parameters of the enterprise-class router.
4.2 Starting the Enterprise-class Router
To use the enterprise-class router, you need to properly configure the enterprise-class router as required. Refer
to the relevant configuration guide and command reference for details about enterprise-class router configuration.
To Next Page
Loading...
Need help?
General
