11
The status of the RXRT510 receiver is indicated by two LEDs. These are
LEDs with the following colors:
- red (upper one),
- green (lower one).
A detailed explanation of the meaning of the LEDs can be found in the table below:
Wyjaśnienie
The red LED lights up
The receiver is connected to the 230V power supply and is paired with the thermostat.
The receiver can be thermostat-enabled if it is in automatic mode when the lower switch is in the AUTO position.
The receiver can be started manually when the lower switch is in the MANUAL position.
The red LED ashes
The receiver is in the pairing mode and is looking for a signal from the thermostat (then you must activate the
“PAIRING” option in the thermostat)
(or)
The receiver was paired but lost communication with the thermostat due to out of range or low battery in the
thermostat. The receiver starts ashing after one hour of time when it does not receive a signal from the thermostat.
The red diode is o The receiver is disconnected from the 230V power supply or the upper switch is in the OFF position.
The green diode lights up
In automatic mode, the receiver received a heating signal from the thermostat.
The receiver was started in manual mode (upper ON switch, lower MANUAL switch)
The green diode is o The receiver does not send a heating signal.
4.2 LED indications in the receiver
1
2
1
2
To Next Page
Loading...
Need help?
General
