To Next Page

To Previous Page

The RT310 room thermostat simply switches the heating system on and o as necessary. It works by sensing the air temperature, switching on the heating

when the air temperature falls below the thermostat setting, and switching it o once this set temperature has been reached.

Turning a room thermostat to a higher setting will not make the room heat up any faster. How quickly the room heats up depends on the design of the

heating system, for example, the size of boiler and radiators. Neither does the setting aect how quickly the room cools down. Turning a room thermostat

to a lower setting will result in the room being controlled at a lower temperature, and saves energy.

The way to set and use your room thermostat is to nd the lowest temperature setting that you are comfortable with, and then leave it alone to do its

job. The best way to do this is to set the room thermostat to a low temperature – say 18⁰C – and then turn it up by one degree each day until you are

comfortable with the temperature.

You won’t have to adjust the thermostat further. Any adjustment above this setting will waste energy and cost you more money.

If your heating system is a boiler with radiators, there will usually be only one room thermostat to control the whole house. But you can have dierent

temperatures in individual rooms by installing thermostatic radiator valves (TRVs) on individual radiators. If you don’t have TRVs, you should choose a

temperature that is reasonable for the whole house. If you do have TRVs, you can choose a slightly higher setting to make sure that even the coldest room

is comfortable, then prevent any overheating in other rooms by adjusting the TRVs.

Room thermostats need a free ow of air to sense the temperature, so they must not be covered by curtains or blocked by furniture. Nearby electric res,

televisions, wall or table lamps may prevent the thermostat from working properly.

Product advantages:

• set factory-paired and ready to work

• has a TPI control algorithm

• automatically repeats the signal

• has a frost protection mode (temperature range 5 - 17 degrees)

• correction of the displayed temperature ± 3ºC

• has a SLEEP mode (suspending the function, e.g. outside the heating season)

• has unique transmission codes

• operates at 868 MHz - a stable and noise-resistant signal

• heat/cool mode operation*

* Function available only from rmware version 2.1