15
5.2 Frost protection mode
5.3 Sleep mode
In this mode the setpoint temperature is automatically set to frost setpoint to prevent pipes from freezing. If the room temperature is lower than the frost
setpoint, frost protection will be enabled. To set frost protection mode follow steps below:
In sleep mode thermostat is switched o and doesn’t consume any energy and it is impossible to make an action until you activate the thermostat again.
To activate/deactivate sleep mode follow steps below:
TO DEACTIVATE SLEEP MODE:
TO ACTIVATE SLEEP MODE:
Press button to turn
ON/OFF frost protection.
Press and hold
+ buttons
simultanously to turn ON sleep mode.
In sleep mode thermostat’s
display is blank.
To deactivate sleep mode press any
button.
Thermostat will go back to work and
display main screen.
Snowake icon will be displayed if
frost protection is active.
The Frostpoint temperature can be reviewed by pressing the UP button once, but can only be changed in Installer Mode. Frost protection mode
can be enabled only in HEAT mode.
1
1
1 2
2
2
3 sec
3 sec
To Next Page
Loading...
Need help?
General
