English _25
● OVERVIEW
Item Description
a
Internal Cover It is a cover to protect the main body.
b
Lens
Lens for the camera.
c
Zoom/Focus Control
Button
T Zoom in (Tele)
W Zoom out (Wide)
N Focusing on a near object (Near)
F Focusing on a far object (Far)
Focus Control Press this button for automatic focus control.
d
Reset Button
The button restores all camera settings to the factory default.
Press and hold for about 5 seconds to reboot the system.
J
If you reset the camera, the network settings will be adjusted so that
DHCP can be enabled. If there is no DHCP server in the network, you
must run the IP Installer program to change the basic network settings
such as IP address, Subnet mask, Gateway, etc., before you can
connect to the network.
e
Test Monitor Out
Output port for test monitoring the video output. Use the test monitor cable
to connect to a mobile display and check the test video.
f
Alarm I/O Port
ALARM IN
Used to connect the alarm input sensor or external day/
night sensor.
ALARM OUT Used to connect the alarm output signal.
GND Used for earth-grounding.
g
Power Port Used to plug the power cable.
h
Micro SD Memory
Card Compartment
Compartment for the
Micro SD memory card.
i
Audio Out Jack Used to connect to speakers.
j
Audio In Jack Used to connect to a microphone.
k
Network Port Used to connect the PoE or Ethernet cable for network connection.
To Next Page
Loading...
Need help?
General
