English _47
●
NETWORK CONNECTION AND SETUP
3. In the <Address> pane, provide the
necessary information.
•MAC (Ethernet) Address : The MAC
address imprinted on the camera
label is automatically displayed and
requires no user setting.
M
`
IP related parameters can be set only
when DHCP is not checked.
If not using a Broadband Router
For setting <IP Address>, <Subnet Mask>, and <Gateway>, contact your network
administrator.
4. In the <Port> pane, provide necessary
information.
•HTTP Port : Used to access the
camera using the Internet browser,
defaulted to 80.
•VNP Port : Used to control the video
signal transfer, defaulted to 4520.
5. Enter the password.
Enter the password of “admin” account, which was used to access the camera.
The default password is “4321”.
J
`
The default password can be exposed to a hacking thread so it is recommended to change the
password after installing the product.
Note that the security and other related issues caused by the unchanged password shall be
responsible for the user.
`
If you want to change the password, refer to “Administrator password change” of the user
setup. (page
132)
6. Click [OK].
Manual network setup will be completed.
To Next Page
Loading...
Need help?
General
