English _29
● INSTALLATION & CONNECTION
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.
J
`
When connecting PoE and DC 12V, or PoE and AC 24V at the same time, the unit starts operation
with the first connected power.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE 802.3af protocols.
`
The heater operates at a low temperature environment in all cases that the dome camera is
operated by PoE, AC 24V or DC 12V.
- Install the product at the temperature of -35°C or higher.
- The product can be operated down to the temperature of -40°C after it started up.
`
Be careful not to reverse the polarity when you connect the power cable.
`
AC 24V can be connected in non-polar union.
`
If you want to connect an external device, you must turn off the external device before proceeding.
To Next Page
Loading...
Need help?
General
