setup screen
To use Motion detection
It detects a motion that meets all conditions specified by sensitivity, size and area.
1. Select a motion detection mode.
2. Select <Sensitivity> tab to set the
sensitivity level. You can set the sensor’s
sensitivity to detect a motion out of the
background from the monitoring video.
J
`
In a situation that definitely distinguishes
objects out of backgrounds, set this to
a low sensitivity level. For opposite case
that is hard to distinguish objects like low
illuminated situation, set this to a high
level.
3. Select <Size> tab.
You can limit the minimum/maximum
size of motion to be detected.
• Minimum size : To set the minimum
size of detected motions, select
<Minimum size> and then point
and drag to the desired size on the
screen using the mouse.
• Maximum size : To set the maximum
size of detected motions, select
<Maximum size> and then point
and drag to the desired size on the
screen with your mouse.
J
`
Motions smaller than the specified minimum size or bigger than the maximum size are not
detected. To avoid unintended detections caused by great and small noises, set minimum/
maximum motion sizes appropriately in accordance to your environments.
Note that same motions on the same location can be differently detected in their detection size;
it is recommended to consider and include the tolerable difference when setting the minimum/
maximum detection sizes.
98_ setup screen
To Next Page
Loading...
Need help?
General
