Sanyo PLV-Z5 User Manual

19
Basic Operation
Press the POWER ON/STAND-BY button on the top control
or on the remote control. “Power off?” appears on the
screen. Press the POWER ON/STAND-BY button again to
turn off the projector.
When the Power off confirmation function is set to “Off,”
the projector can be turned off without the confirmation
message. (See “Power off confirmation” on page 38.)
The automatic slide shutter closes and the POWER indicator
starts to blink red. The blinking continues for about 60
seconds while the cooling fans are running.
1
TO MAINTAIN LIFE OF LAMP, ONCE YOU TURN PROJECTOR
ON, WAIT AT LEAST FIVE (5) MINUTES BEFORE TURNING IT
OFF.
DO NOT UNPLUG AC POWER CORD WHILE COOLING FANS
ARE RUNNING OR BEFORE POWER INDICATOR STOPS
BLINKING. OTHERWISE IT WILL RESULT IN SHORTENING
LAMP LIFE.
2
When the projector is cooled down enough to be turned on
again, the POWER indicator becomes red. Then you can turn
the Main On/Off switch off and unplug the AC power cord.
“Power off?” disappears after 4 seconds.
Tu r ning Off the Projector
✔Notes:
•If the automatic slide shutter is closed during operation, the projector is automatically
turned off for safety. Be sure to turn off the projector by pressing the POWER
ON/STAND-BY button on the top control or on the remote control after use.
• While the POWER indicator is blinking, the lamp is being cooled down and the
projector cannot be turned on. Wait until the POWER indicator becomes red to be
turned on again.
•Do not operate the projector continuously without rest. Continuous use may result in
shortening the lamp life. Turn off the projector and let stand for about an hour in
every 24 hours.
• The running speed of cooling fans is changed according to the temperature inside
the projector.
• If the WARNING indicator blinks or emits red light, see “Warning Indicator” on page
42.
• Do not put the projector in a case before it is cooled enough.

Sanyo PLV-Z5 Specifications

General

Number of colors	1.073 billion colors
Vertical scan range	50 - 100 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	40 - 300 \
Projector native resolution	1280x720
Keystone correction, vertical	± 20 °
Digital zoom	2 x
Zoom capability	Yes
Focal length range	21.3 - 42.6 mm
RS-232 ports	1
Compatibility	WXGA/SXGA/XGA/SVGA/VGA/MAC
Dimensions (WxDxH)	382 x 304.3 x 126.8 mm
Power requirements	100 - 240 V
Horizontal resolution	420 lines
Lamp type	UHP
Lamp power	145 W
Light source type	Lamp
Service life of light source	3000 h
Dot clock scanning frequency	100 MHz
Serial interface type	RS-232
Display diagonal	0.7 \
Power consumption (typical)	185 W
Storage temperature (T-T)	-10 - 60 °C
Operating temperature (T-T)	5 - 35 °C

Weight and Dimensions

Weight	5000 g