Receiving a Ready Link Call
To receive a Ready Link call:
1. Make sure your phone’s Ready Link mode is enabled (see
“Setting Ready Link Mode” on page 124).
2. When you receive a Ready Link call from a contact, “R-Link
Call,” the contact’s name, and the Ready Link number appear on
the display. (You do not need to take any action to answer the
call.)
䡲
When you receive a group call, “Group Call” and the
Ready Link number appear.
䡲
If nobody takes the floor for 20 seconds, the call will be a
missed Ready Link call.
3. If the person placing the call has kept the floor (held the
Ready Link/Memo button), you will see the contact name and
Ready Link number along with “has floor.,” and you will hear the
caller speaking.
4. When the caller finishes speaking and releases , you will
see “Floor is open.” on the display screen. Press and hold to
take the floor and reply to the caller. (You will see “You have floor.”
and hear a tone confirming that you may speak.)
5. When the conversation is finished, press .
Tip:You can also receive a Ready Link call with the flip closed. Press and hold
to take the floor when the floor is open.
Note:You can change the volume and the speakerphone setting while a
Ready Link call is activated.
Volume: Adjust the voice volume by using the Side
Up/Down key or by pressing the navigation key up or down except when you are
pressing and holding
. Speaker: Switch the speakerphone on or off by
pressing .
Section 2J: Using Ready Link 131
To Next Page
Loading...
Need help?
General
