45
Display
1. Display the current day of the week / Select day,
days in settings
2. Main information display
3. Not used
4. RF connection (if flashing, check connection)
5. Info number of current function
6. Mode of setting settings (heating, thermostat
setting,…)
7. Symbol for manual temperature setting
a. If symbols 7 and 8 are on, it means that you have a
temporary temperature change on, which will be valid until the next start of the heating program.
b. If only the symbol 7 is switched on, without the symbol 8, it means that you have the permanently set
temperature switched on and the heating programs are switched off
8. Symbol that heating program schedule is currently turned on.
9. If heating is required, say the desired room temperature is higher than the room temperature, the
heating is switched on and this symbol is switched on.
10. This symbol is displayed when the anti-freeze function is activated automatically
11. Display of the selected temperature sensor and thermostat operating mode (change the mode in the
settings)
a. symbol means that only the internal temperature sensor is in use (default)
b. symbol means that only an external temperature sensor is in use (NTC10K or NTC100K)
c. symbol means that both sensors (external and internal) are in use
12. In the thermostat settings editing mode, the current setting you are editing is displayed here. In case
of bad batteries, the text
bl (battery low) will be displayed here - battery replacement required
13. Display of the current heating program or for which program the heating is currently being set
To Next Page
Loading...
Need help?
General
