THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
28
4.5.2 Electric connections: wires (MODULAR 150 230V AC)
The electric connectors are positioned inside the small electric box connected to the computer box. The power
supply, coming from the power generator, needs to be connected to the specifical terminals of the pump box.
The connection to the vessel panel needs to be performed downstream the voltmeter and the ammeter of the
vessel panelboard. The connecting terminal must be suitable to support the plant electric load (approx. 600
Watt). A 5 Ampere automatic circuit breaker for 230V AC systems must be installed on the power supply.
The computer box will be powered 12-24V, directly from the service batteries or through a 230/12-24 charger.
The connection general diagram is the following:
Clamp Position connect to cable section
T Pump box 230 V power generator (ground) 2,5 mm2 min.
F Pump box 230 V power generator (phase) 2,5 mm2 min.
N Pump box 230 V power generator (neuter) 2,5 mm2 min.
P1 Pump box Computer box 2,5 mm2
- Pump box Computer box 2,5 mm2
EV Computer box electrovalve (on the AC filter) 2,5 mm2
EV Computer box electrovalve (on the AC filter) 2,5 mm2
PS Computer box Signal pressure switch 2,5 mm2
PS Computer box Signal pressure switch 2,5 mm2
+ Computer box positive battery/charger 2,5 mm2
- Computer box negative battery/charger 2,5 mm2
Connection between the computer box and remote panel.
Connect the remote panel to the computer box using pre wired cable supplied (standard length 10 mts.)
To Next Page
Loading...
Need help?
General
