THE PRESENT MANUAL BELONGS TO - Schenker Italia - ALL RIGHTS RESERVED
38
5.4 Normal operating procedure
Please, be sure to perform all the following checks before proceeding normal operating procedure:
1. Be sure the reset valve is closed (lever orthogonal to the body valve) and the positioner completely
unscrewed.
2. Be sure the depressurization valve is closed.
5.4.1 Normal operating procedure without final flushing
1. Press START to turn on the watermaker.
2. Press STOP to turn off the watermaker.
5.4.2 Normal operating procedure with final flushing (recommended procedure)
1. Press START to turn on the watermaker.
2. Press FLUSH to set the final flushing.
3. Press STOP to turn off the watermaker; FLUSH starts blinking. The fresh water consumed for the
automatic washing is about 20 lt.
4. The system can be stopped at any time by pushing STOP.
5.4.3 Working cycle with timer
1. Select the working time of the watermaker (1-6
hours) by pressing on the arrow ”>”.
2. Press START in the function to turn on the
watermaker
3. The unit can be stopped at any time by pressing
STOP (without final flushing) or by pressing
FLUSH then STOP(with final flushing).
1. Turn on the watermaker by pressing START in
the MANUAL WASH function. A 10-minute
flushing procedure starts
2. The unit can be stopped at any time by pressing
STOP
NOTE
It could occur that the system doesn’t stop immediately when stop button is pushed, but it rather
stops after a while. This behaviour is absolutely normal because the electronic central unit waits for
the hydraulic clock signal before switching off in order to avoid hydraulic system block.
To Next Page
Loading...
Need help?
General
