Scheppach HBS30 User Manual

www.scheppach.com
28
|
GB
1x Flat washer M6 (37)
1x Nut M6 (38)
2x Screw M5x7 (39)
2x Serrated washer M5 (40)
1x Original operating manual
Optional:
1x Cross cutting gauge (25)
1x Saw band (6 teeth/inch)
1x Saw band (10 teeth/inch)
1x Saw band (15 teeth/inch)
4. Intended use
The band saw is designed to perform longitudinal and
        

-

The user / operator and not the manufacturer will be

a result of this.



and the operating instructions to be found in this man-
ual.
All persons who use and service the machine have to
be acquainted with this manual and must be informed
about the machine’s potential hazards. It is also imper-
ative to observe the accident prevention regulations in
     



such changes.
Even when the machine is used as prescribed it is still
impossible to eliminate certain residual risk factors.

machine’s construction and design:
• 󰀨-

• Harmful emissions of wood dust when used in
closed rooms.
• Contact with the blade in the uncovered cutting
zone.
• 
36. Screw M6x35
37. Flat washer M6
38. Nut M6
39. Screw M5x7
40. Serrated washer M5
41. Knurled nut for parallel stop
42. Clamping lever for parallel stop
43. Guide rail for parallel stop
44. Inspection glass
45. Allen screw for top support bearing
46. Top support bearing
47. Top guide pin
48. Allen screw for top guide pins
49. Retainer (top)
50. Allen screw top retainer (2x)
51. Allen screw bottom support bearing
52. Bottom support bearing
53. Screw bottom retainer
54. Saw band protection
55. Allen screw for bottom guide pins
56. Bottom guide pin
57. Retainer (bottom)
58. 
59. 
60. Push Stick retainer
3. Scope of delivery
• Open the packaging and remove the device care-

• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• 
•      -
port damage.
• 
period has expired.
m ATTENTION! The device and packaging materials


󰀨
1x Band saw
1x Saw table (7)
1x Table extension (8) with guide rail (43)
1x Parallel stop (14)
1x Push stick (29)
1x Open-end spanner, size 10/13 (34)

1x Screw M6x35 (36)

Scheppach HBS30 Specifications

General

Product type	Vertical band saw
Product color	Blue, Grey
Built-in light	-
Adjustable speed	Yes
Housing material	Steel, Aluminium
Table bevel angle	0 - 45 °
Input power	350 W
Power source	AC
AC input voltage	230 - 240 V
AC input frequency	50 Hz
Cutting width	- mm
Cutting height @ 90°	80 mm
Number of teeth per inch (TPI)	6, 10, 15

Weight and Dimensions

Depth	730 mm
Width	420 mm
Height	540 mm
Weight	20500 g
Table depth	520 mm
Table width	300 mm