www.scheppach.com
GB
|
29
Thicknessing table
size
350 x 270 mm
Drive
Motor V/Hz 230 - 240 V / 50 Hz
Consumption power
P1
1500 W
Subject to technical changes!
Noise
Total noise values determined in accordance with EN
61029.
Sound pressure level L
pA
= 92 dB(A)
Sound power level L
wA
= 105 dB(A)
Uncertainty K
pA/wA
= 3 dB
Wear hearing protection.
The eects of noise can cause a loss of hearing
The above-mentioned noise emission values were
measured in accordance with a standardised test pro-
cedure and can be used to compare one power tool
with another.
The above-mentioned noise emission values can also
be used for the preliminary assessment of exposure.
Warning:
• The noise emissions during the actual use of the
power tool may dier from the above-mentioned
values depending on the power tool being used, in
particular on the type of workpiece being processed.
• Try to keep emissions as low as possible, for ex-
ample by limiting your working time. In this regard,
all the operational cycle phases must be taken into
consideration (such as the times when the tool is
switched o or running idle).
7. Unpacking
• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage. Inform the transport agent immediately of
any faults. Later complaints cannot be considered.
• If possible, store the packaging until the warranty
period has expired.
• Familiarize yourself with the machine with the help
of the operating instructions manual before using it.
• Do not load the machine unnecessarily: excessive
pressure when sawing will quickly damage the saw
blade, which results in reduced output of the ma-
chine in the processing and in cut precision
• Use the tool that is recommended in this manual.
In doing so, your machine provides optimal perfor-
mance.
• Hands may never enter the processing zone when
the machine is in operation.
• Release the handle button and switch o the ma-
chine prior to any operations..
• Danger of injury! of ngers and hands by con-
tact with the blade shaft at uncovered areas when
changing tools. These can also be crushed by open-
ing the guard.
• Eye injuries
- On the infeed and discharge opening by danger-
ous recoil
- Danger from current if the electric cables have not
been connected correctly.
- harmful wood duct may be generated if operated
without an extractor or chip bag.
- by catapulted parts
• Metal parts in the workpiece can blunt or destroy the
blades.
• Lung damage if no suitable protective dust mask is
used.
6. Technical data
Number of knives 2 pieces
Cutter block rpm 9000 1/min
Dimensions 945 x 450 x 483 mm
Weight 26,5 kg
Technical data – Surfacing
Max planing width 254 mm
Max chip removal 2 mm
Ripping fence l x h 640 x 127 mm
Ripping fence tilting
angle
90° - 135°
Surfacing table size 920 x 264 mm
Technical data – Thicknessing
Max planing width 254 mm
Max planing thick-
ness
120 mm
Max chip removal 2 mm
To Next Page
Loading...
Need help?
General
