www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
37
16. Troubleshooting
Fault Possible causes Action
Blade dissolves after
switching off the engine
To slightly tightened fastening nut Tighten the right hand thread nut
Engine will not start Failure mains fuse Check mains fuse
Defective extension cable Replace extension cord
Connections on motor or switch not
in order
Repair by electrical specialist
Motor or switch faulty Repair by electrical specialist
Motor will not work, the
fuse is active
Cross section of the extension
cable is not sufcient
See „Electrical connection“
Overload by a blunt saw blade Change saw blade
Fire marks on the
cutting surface
Blunt saw blade Have saw blade sharpened (only by an authorised
sharpening specialist) or change it
Wrong saw blade Change saw blade
To Next Page
Loading...
Need help?
General
