Shure AD4Q User Manual

Device RF
RF Band
Select the tuning band for the receiver.
Encryption
Enables encryption of the RF signal.
Transmission Mode
Select Standard or High Density transmitter spacing.
Quadversity
Enable Quadversity mode to configure RF ports to accept four antennas.
Custom Groups
Configure, edit, or load custom frequency groups.
Antenna Bias
Enable antenna bias for active RF antennas.
TV Format
Adjust TV bandwidth to match regional standards.
Device Audio
AES3 Audio
Configure AES3 audio parameters.
Dante Names
View, edit, and copy names for networked Dante components.
Device ID
Device ID
Use the control wheel to assign or edit an ID.
Network Configuration
Configure IP, network, and Dante settings.
Setup
Configure Ethernet ports and IP settings.
Access
View the status of Access Control (Enabled or Disabled). Use Wireless Workbench or other Shure control software to enable or disable Access Control.
Network Browser
Use to discover Dante devices on your network.
Show
Display all devices on the network.
Flash All
Flash the front panel LED of all devices on the network to verify connectivity.
F.W. Version
Display the installed firmware version of the selected network component.
Locks
Power Switch
• Locked
• Unlocked
Front Panel
• Locked
• Unlocked
Fan
Fan Mode
• Auto: The fan will automatically turn on if the receiver temperature rises
• On: The fan will run continuously to offer maximum cooling in warm environments
Temperature
Displays internal receiver temperature.
Shure IncorporatedAD4Q Digital Quad Receiver
7/212017/10/25

Shure AD4Q Specifications

General

Brand	Shure
Model	AD4Q
Category	Receiver
Language	English