Shure Incorporated
12/27
1.
2.
3.
Example Scenario
A common application that requires summing is a video conference where there are multiple microphones. When a device (a
computer running conferencing software and Dante Virtual Soundcard, for example) only supports 1 or 2 Dante receiver chan
nels, the Audio Network Interface combines the input signals to transmit as a single Dante channel.
① Summed analog audio channels
When the 4 analog audio channels are summed, each of the Dante transmit channels includes all of the input signals.
② Single Dante audio channel
One Dante signal is sent over the network, which contains all 4 summed channels.
③ Connection to computer
A computer that is running limited number of Dante channels with Dante Virtual Soundcard, receives all audio on a single
channel. This audio is sent to the far end.
Encryption
Audio is encrypted with the Advanced Encryption Standard (AES-256), as specified by the US Government National Institute of
Standards and Technology (NIST) publication FIPS-197. Shure devices that support encryption require a passphrase to make
a connection. Encryption is not supported with third-party devices.
To activate encryption:
Open the Settings menu and select the General tab.
Select Enable Encryption.
Enter a passphrase. All devices must use the same passphrase to establish an encrypted connection.
Important: For encryption to work, all Shure devices on your network must use encryption.
If you’re using Shure Designer software to configure your system, please check the Designer help section for more about this topic.
To Next Page
Loading...
Need help?
General
