7
SE80/185T & SE100/185T Ignition Protected thruster assembly 1.0 - 2007
1. Turn the propeller shaft so that the drivepin (5) is in a horizontal position and ensure that it is centred in the propellershaft.
2. Push the propellers onto the shaft with the track for the drivepin in an horizontal position (same direction as you set the drivepin), all
the way in. There should be almost no gap between the propeller hub and the gearhouse.
3. Place the washer (4) on the prop.shaft and then tighten the lock-nut (3) on the propeller shaft.
4. Place the zinkanode (2) in its designated position and tighten the zincanode holding screw (1). Apply a thread glue (Locktite or
similar) to ensure that the zincanode holding screw does not un-screw itself from the propellers rotation.
Parts description:
1 : Screw for zincanode
2 : Zincanode
3 : Propeller lock nut
4 : Washer
5 : Drivepin for propeller
Fitting propellers
5
3
2
1
4
Locktite
To Next Page
Loading...
Need help?
General
