Accessories
4.11 Test devices
3VA molded case circuit breakers
408 Manual, 04/2015, A5E03603177010-02
Executing the test functions using a PC and powerconfig
In addition to its capabilities as a stand-alone test device, the TD500 can also act as a PC
interface to the ETU.
If the TD500 test device is connected both to the ETU and a PC, the protective functions can
be triggered from a PC on which the powerconfig software is installed. A test log for the
molded case circuit breaker is generated and stored in the powerconfig project. The test log
can be printed out.
Connections between ETU - TD500 - PC
Plug-in connector for insertion in the test
socket on the ETU
Power supply unit
TD500-to-ETU connecting cable
USB connecting cable
TD500 test device
PC with powerconfig installed
Parameterizing using the powerconfig software
In addition to test functions, the powerconfig software package also provides tools for
assigning parameters to ETU 5-series and 8-series.
These tools allow you to:
● assign parameters to ETU 5-series and 8-series
● store parameter settings for ETU 5-series and 8-series in the powerconfig project and
print them out
To Next Page
Loading...
Need help?
General
