inbetriebnahme.fm
A31003-O1010-M100-9-76A9, 05/05/2008
HiPath 8000 - OpenStage Family, Administration Manual
2-7
Startup
Quick Start
2.3 Quick Start
This section describes a typical case: the setup of an OpenStage endpoint in an environment
using a DHCP server and the web interface. For different scenarios, cross-references to the
corresponding section of the administration chapter are given.
2.3.1 Access the Web Interface (WBM)
1. Open your web browser (MS Internet Explorer or Firefox) and enter the transfer protocol,
IP address and port number of your phone. If HTTP is used, port 8085 must be added, for
example http://192.168.1.15:8085. For HTTPS, the phone uses the standard port 443.
After entering the URL, the browser might display a certificate notification. The start page
of the web interface appears. In the upper right corner, the phone number, the phone’s IP
address, as well as the DNS name assigned to the phone are displayed. The left corner
contains the user menu tree.
>
Alternatively, the DLS (Deployment Service) administration tool can be used. Its
Plug & Play functionality allows to provide the phone with configuration data by as-
signing an existing data profile to the phone’s MAC address or E.164 number. For
further information, see the Deployment Service Administration Manual.
>
Any settings made by a DHCP server are not configurable by other configuration
tools.
To Next Page
Loading...
Need help?
General