administration.fm
A31003-O1010-M100-9-76A9, 05/05/2008
HiPath 8000 - OpenStage Family, Administration Manual
3-21
Administration
IP Network Parameters
Administration via Local Phone
3.3.8 SNMP
The Simple Network Management Protocol is used by network management systems for mon-
itoring network-attached devices for conditions that warrant administrative attention. An SNMP
manager surveys and, if needed, configures several SNMP elements, e.g. VoIP phones.
The OpenStage phone supports SNMP version 1 and 2.
There are currently 4 categories of trap that can be sent by the phones:
Standard SNMP traps
OpenStage phones support the following types of standard SNMP traps, as defined in RFC
1157:
• coldStart: sent if the phone does a full restart.
• warmStart: sent if only the phone software is restarted.
• linkUp: sent when IP connectivity is restored.
QoS Related traps
These traps are designed specifically for receipt and interpretation by the QDC collection sys-
tem. The traps are common to SIP phones, HFA phones, Gateways, etc.
Traps for important high level SIP related problems
Currently, these traps are related to problems in registering with a SIP Server and to a failure
in remotely logging off a mobile user. These traps are aimed at a non-expert user (e.g. a stan
-
dard Network Management System) to highlight important telephony related problems.
Traps specific to OpenStage phones
Currently, the following traps are defined:
TraceEventFatal: sent if severe trace events occur; aimed at expert users.
TraceEventError: sent if severe trace events occur; aimed at expert users.
|
--- Administration
|
--- Network
|
--- Update Service (DLS)
|--- DLS address
|--- DLS port
|--- Contact gap
|
--- Security status
To Next Page
Loading...
Need help?
General